Lead Free EnviroSafe Tinning Paint
Containing only a lead free alloy solder powder and our special flux, Lead Free EnviroSafe Action Tin can be used with EnviroSafe solder on all sanitary, food, and other environmentally sensitive applications. (Can also be used with other solders.) Large copper, brass and other tubular materials can be sweat soldered with complete coverage by tinning surface first with Action Tin, then fluxing, assembling and soldering. Perfect soldering is achieved when the two surfaces in contact are metallurgically bonded together by the solder. The entire area is covered and there are no voids. Action Tin wets each surface entirely and you can see this before soldering. It pre-tins not only copper and brass, but also hard to solder materials such as steel, iron, stainless steel, cast iron, beryllium copper, terne plate, lead flashings, and lead coatings. After pre-tinning, you can then assemble using any flux and solder.

Solder-MagicAction-Tin Tinning Paint
Tinning Paints are used for pre-tinning of any product, but especially for difficult to solder applications. They are applied, as the name implies, as a paint. The paints are more fluid because they lack a thickening agent, therefore the paint requires stirring prior to use. Typical metal content is up to 30% by weight. The paint is brushed or wiped onto the surface and reflowed by oven, torch or iron. It is available in most common soldering alloys.
The highly active zinc chloride based flux system is appropriate for many types of industrial solder alloys and base metals. Warm water is used to clean any residues, especially for critical metal surfaces. These products are not appropriate for sensitive electronic applications.
Safety Considerations:
Personal protection should include eye protection, chemical resistant gloves, and apron/lab coat. Avoid contact with skin and avoid breathing fumes. Use in a well ventilated area. Refer to the Material Safety Data Sheet for more information.

Use Guidelines:
Paints: Store between 4 and 25°C. Stir well before each application. Keep covered. To make thicker – let stand for 1 hour, pour off the small amounts of liquid until desired consistency is reached. Dispose of used paste per all appropriate laws and regulations.